Install the four M3x8 screws that fasten the controller ECA to the chassis shown below. Assembly Notes To install the elevator assembly, do the following. Top Case The top case LP Use a known good remote with the projector. Page 97 badtint Bad or missing tint or color. Remove the bottom case see page

Uploader: Metaxe
Date Added: 14 November 2006
File Size: 31.4 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 59058
Price: Free* [*Free Regsitration Required]

Lamp blower xx Lamp housing LP Rear Bezel InFocus nameplate xx fastens to the rear bezel over the screw.

INFOCUS Lpb – DLP Projector | eBay

Turn the zoom ring to make the smallest image. Mobile by Stephen Shankland 8 days ago. The DMD may fall out.

The new software version number appears in the Status window. Page 54 Route the fan and blower cables so they emerge on between the color wheel housing and the lo340b housing.

Do not touch l;340b with your fingers. Leveling Foot The leveling foot xx is located on the rear corner adjacent to the lamp housing. Act like your business depends on them Backups: If the bias setting on the controller ECA correctly corresponds with the setting on the DMD label, you leave the setting as it is. Install the four M3x8 screws that fasten the controller ECA to the chassis shown below. Page 59 Remove the lp34b switch assembly from the projector. Does If speaker sounds bad Measure it measure Replace it may be a bad speaker cone.

  AMILO XI 1526 BLUETOOTH DRIVER DOWNLOAD

Page 98 dimimage Dim image Substitute known good lamp. It is located next to the text, Synchronizing Comm link Press the power button on the projector within five seconds of the appearance of the timer. Upgrade the Software Open Windows Explorer, navigate to the batch file, then double-click the batch file TI in this example. The connections are the same as that used to upgrade the software. The lamp will not light if the color wheel is not spinning. Cable modem shopping tips Cable modem shopping tips by Dong Ngo.

EXE file and install the upgrade software on the computer you plan to use to flash the projector.

So, Why Buy from TeKswamp?. Elevator The elevator assembly xx is comprised of three pieces: This allows the power switch and plug to clear the edge of the case.

A frame made of metal and plastic holds the reflector assembly in place inside the projector. This Infocus DLP projector has a long lamp life and is quite while in operation.

  EP-4PLMI ETHERNET DRIVER

Focus the image so the middle icon is clearly focused.

Infocus LPB Projector Lamp with

Open the Serial Interface Utility on the computer. Do not remove the DMD from its location on the optical engine. But what is the best way to make sure that you are buying from a trustworthy source? The switches fasten to the top and side of the lamp housing.

Seat the actuator end so that it goes through the elevator housing. Place the two EMI clips on opposite corners. You remove the chassis and these infoocus units from the top case as one piece.

Infocus LP340B Projector Lamp with Module

Page 32 Align the AC receptacle with its opening ifnocus the top case first. Fasten the bezel to the projector with the black M3x8 screw. Trending Price New.